Replacing Carbon Brushes; Optional Accessories - Makita 9401 Instruction Manual

0
Replacing carbon brushes
Remove and check the carbon brushes
regularly. Replace when they wear down
t o the limit mark. Keep the carbon
brushes clean and free to slip in the
holders. Both carbon brushes should be
replaced a t the same time. Use only iden-
tical carbon brushes.
/
Limit mark
Optional accessories
CAUTION: The accessories specified in this manual are recommended for use with your Makita
Belt Sander. The use
of
any other accessory might be hazardous.
0
Abrasive belts
Belt
type
and use
A A
-
For wood. iron and steel
Grit
I
Part No.
I
Use
I
,",:",",',",
742322-9
Coarse
Medium
5
0
Carbon plate *Steel plate
0
Step
Part No. 423029-3 Part No. 342328-3 Part No. 342332-2
CAUTION :
Install the steel plate so that THE EDGE OF THE STEEL PLATE W I L L NOT
PROTRUDE FROM THE EDGE OF THE FRAME ON THE SIDE WITH THE
BELT INSTALLING LEVER.
I F THE PLATE I S ALLOWED TO PROTRUDE. I T MAY CAUSE INJURY.
6