Semi-Matic (Bump-Feed) Cutting-Line Head - Honda HHT25S Owner's Manual

5. When you have about 6
inches (150 mm) of line
remaining, press the lines
into the two notches on the
bottom of the spool. This will
hold the lines on the spool
for reassembly.
6. Feed both line ends through
the metal eyelets in the
housing.
Be careful not to let the line slip under the spool. When the spool
reaches the bottom of the housing, the lines should snap out of the
spool notches.
If you are not sure the lines have snapped out of the notches,
gently pull the spool away from the housing about an 1/8 inch to
inspect the lines. If necessary, gently pull each line until you hear it
snap out of the notch. Trim the lines so they are equal length.
7. Install the spring and knob. Rotate the knob in the direction of the
arrow and hand tighten securely.

Semi-Matic (Bump-Feed) Cutting-Line Head

Line is released from the cutting head by bumping the spool on hard
ground while the head is spinning. Do not tap the cutting-line head on
pavement or concrete.
HOUSING
1. Clean any mud, dirt, debris, etc., from around the trimmer head
area; otherwise, it will be more difficult to service.
22
NOTCHES
METAL
EYELET (2)
SPOOL
2. Locate the half-round locking hole on the spool.
SPOOL
3. It may be necessary to lightly rotate the spool in the direction of the
arrow about an 1/8 turn until the spool stops.
4. Hold the housing securely, then continue to rotate the spool in the
direction of the arrow an additional 1/4 inch or the width of the
channel to unlock the spool from the housing.
5. Lift the spool out of the housing and remove any remaining line
from the spool.
6. Measure approximately 20 feet (6 meters) of new line, then thread
one end through the hole in the ridge on the spool.
Pull the line until the two lengths are equal.
NYLON LINE
7. Wind both lines tightly and evenly from side to side ignoring the
ridge. Feed the line while turning the spool in the direction of the
arrow. Do not allow the line to get twisted.
HALF-ROUND
LOCKING HOLE
CHANNEL
HOUSING
SPOOL