Table of Contents
Advertisement
gasket
figure 5. hopper gasket positioned.
4.
place the hopper on top of the gasket and
line up all of the holes. place two rubber
grommets and 8mm fender washers on two
M8-1.25 x 35 hex bolts, thread them through
the holes nearest the motor, then secure
them with two 8mm flat washers, 8mm lock
washers, and M8-1.25 lock nuts (see figure
6).
hopper
figure 6. hopper and toolbox attached.
5.
line up the holes in the toolbox with the
remaining holes in the hopper and secure
them with the same combination of hex bolts,
washers, and lock nuts as used in Step 4
(see figure 6).
6.
insert an M8-1.25 x 35 phillips head screw
with an 8mm flat washer through each hole
in the handles. place three 8mm flat washers
on each of the screws and insert the handle
assembly into the holes in the hopper (see
figure 7). secure the handles with one 8mm
flat washer, 8mm lock washer, and M8-1.25
lock nut on each screw.
Model G0594 (Mfg. Since 7/11)
toolbox
x 4
figure 7. location to install the handles.
7.
place the funnel over the studs in the side
of the chipper/shredder and secure it with
the remaining 8mm flat washers, 8mm lock
washers, and M8-1.25 lock nuts (see figure
8).
Funnel
figure 8. Funnel installed.
8.
Before operating, fill the motor with oil and
gas according to the instructions in the Briggs
& stratton manual.
NOtICE
this chipper/shredder does not have oil
in the motor when shipped. Add oil before
operating the chipper/shredder, or the
motor will seize.
x 4
handle
x 3
-9-
Advertisement
Table of Contents
