Step 3. Water Fil - Kenmore 758.299825C Operator's Manual

Step 3. Water Fill
WARNING: To reduce the risk of fire
or shock hazard, do not pour or spill
water into control or motor area.
if controls get wet, let them dry
completely and have unit checked by
authorized service personnel before
plugging in.
After the humidifier is positioned where it
will be operating you are ready to fil! the
humidifier. The bottle lifts straight up and
away from the base. Take care not to
bump or damage fill valve assembly on
the bottom of the bottle.
Remove the "E-Z Fill Side Cap" and fill
with water. Replace cap and twist by
hand until secure. Hold the bottle upright
over the sink. Press up on the valve
plunger for one second to release a small
amount of water. If you hear air bubbles
or see leaks around the "E-Z Fill Side
Cap" or Spring Valve Assembly, retighten
and recheck.
....Base
Turn Countercmockwise to
Remove "E-Z Fill Side Cap"
/
CAUTION: Use only EPA Registered
Bacteriostat. Under no circumstances
should you use water treatment
products designed for Roto belt or
Ultrasonic humidifiers.
Place the water bottle back into the
humidifier base. When positioned
properly, the plunger will open and the
water will flow into the base. The base
will hold the entire contents of the water
bottle. Once the bottle is empty, remove it
and repeat the filling process. The
humidifier is now filled to capacity. To
benefit from less frequent filling let the
humidifier exhaust both the water from
the bottle and the base before filling.
z/
Spring Vamve
Assembmy