Connect Door Arm To Trolley - Craftsman 139.53927 Owner's Manual

INSTALLATION STEP 13
Connect Door Arm to Trolley
Follow instructions which apply to your door type as
illustrated below and on the following page.
SECTIONAL DOORS ONLY
• Make sure garage door is fully closed. Pull the
emergency release handle to disconnect the outer
trolley from the inner trolley. Slide the outer trolley
back (away from the door) about 2" (5 cm) as
shown in Figures 1, 2 and 3.
• Figure 1:
- Fasten straight door arm section to outer trolley
with the 5/16"x1" clevis pin. Secure the
connection with a ring fastener.
- Fasten curved section to the door bracket in the
same way, using the 5/16"x1-1/4" clevis pin.
• Figure 2:
- Bring arm sections together. Find two pairs of
holes that line up and join sections. Select holes
as far apart as possible to increase door arm
rigidity.
• Figure 3, Hole alignment alternative:
- If holes in curved arm are above holes in straight
arm, disconnect straight arm. Cut about 6" (15
cm)from the solid end. Reconnect to trolley with
cut end down as shown.
- Bring arm sections together.
- Find two pairs of holes that line up and join with
bolts, lock washers and nuts.
• Pull the emergency release handle toward the
opener at a 45 ° angle so that the trolley release
arm is horizontal. Proceed to Adjustment Step 1,
page 28. Trolley will re-engage automatically when
opener is operated.
Inner Outer
Trolley
Fastener Clevis Pin
5/t6"xt"
Straight
Door Arm
Emergency
0 _ Release
Door
_- Clevis PEn
5/t6"xt-]/4"
Figure 1
Figure 2
HARDWARE SHOWN ACTUAL SIZE
© ©0
Nut 5116"-18 Lock Washer 5/16" Ring Fastener
5/16"xt" (Trolley) 5/16"x1-1/4" (Door Bracket) 5/16"-18x7/8"
Figure 3
NUtS
5/t6"-t8
LOCk
Washers
5/16"
Bolts
rt6".1 8X7/8"
Cut this end
26