•
Install upper motor bracket under flange of vertical
motor bracket (Figure 6) and attach it using two car-
dage bolts, "/=_'fiat washers, =/_,"Iockwashers and
s/,,'-18 hex nuts.
.
Attach top pahel to upper motor bracket (Figure 6)
using two carriage bolts, '¥=" fiat washers, '/,," lock-
washers and %"-18 he)( nuts.
Rgure 6 - Install Upper Motor Bracket
•
Place stand upright and tighten all leg set hex nuts
with open end wrench.
ASSEMBLE
MOTOR
TO STAND
Refer to Figures 1 and 7, pages 3 and 5.
•
Identify and locate the following parts from the hard-
ware bag:
Motor Pulley
Sl, 18 x 31,"Carriage bolt (4)
"/3="Flat washer (4)
Sl,.. Lockwasher (4)
'/,.'-18 Hex nut (4)
•
Identify and locate the following parts:
Motor - C
•
Remove tape from motor shaft. Make sure the key
stays in the slot.
•
Slide the motor pulley onto the motor shaft until flat
side of pulley hits shoulder on shaft.
NOTE: Make sure hat the hub (shoulder) on the pul-
ley Is on the outside.
•
Tighte_ the two setscrews in the pulley using 3mm
hex wrench,
•
Set the stand assembly on the side.
•
Seat the motor on the vertical motor bracket and make
sure the slots on the motor base plate are aligned with
the slots on'the vertical motor bracket (see Figu;'_7).
Rgure 7 - Assemble Motor to Stand
5
• Attach motor to bracket using cardage bolts, wash_-
ers, IodoNashers and hex nuts.
NOTE: Hand tighten only.You may have to adjust motor
position later when-V=belt is installed.
•
Slowly set the stand upright.
•
Route the cord through the grommet in the stand
front panel.
ASSEMBLE
SWlTCHBOX
TO STAND
•
Identifyand locate the following_
from the hardware
bag:
#8-32 x s/=.Pan Head Screw (2)
#8 Serrated Washer (2)
•
Slide the switchbox in the slot on the front panel
•
Attach switchbox to stand using the pan head
screws and serrated washers.
ASSEMBLE
BED TO STAND
Refer to Figures 1 and 8, pages 3 and 5.
•
Identify_
locate the followingparts from the hardware
bag:
3/8-16x 3/,, Hex head bolt (3)
%" Lockwasher (3)
'/,-20 x '/="Pan head screw (2)
'/,"Flat washer (2)
•
Identify and locate the following parts:
Handwheels-P and V-Belt-E,
WARNING:
Although compact, this tool is heavy. At
least two people are required to lift the tool.
Set the jointer bed assembly on top of the stand.
• Align the three holes in the bed with the three slots
on the stand.
•
Attach the three bolts and Iockwashers and tighten.
Figure 8 - Assemble Bed to Stand
• Slip the V-belt over the drive pulley.
•
Lift the motor and slip the V-belt around the motor
pulley.
NOTE: Visually align the motor and drive pulleys and
tighten the motor mounting bolts.
•
Slide the handwheel onto the elevation screw on the
infeed table and secure it using the screw and flat
washer. Repeat for attaching the handwheel to the
ouffeed table.