Advertisement
-
i ....
WARNING:
Do not attempt assembly if parts are
missing. Use this manual to order replacement parts.
ASSEMBLE
STAND
Refer to Figures I and 2, pages 3 and 4.
•
Identify and locate the following parts from the hard-
ware bag:
%-18 x 3/4.Carriage bolt (16)
,3/=. Flat washer (16)
%" Lockwasher (16)
51,6"-18Hex nut (16)
•
Identify and locate the following parts:
Top panel ° G
_
Stand front panel - H
Stand rear panel - I
Stiffners - J (2)
Panel
Lockwasher
Washer
FrontPanel
Rgure 3
Install Leveling Feet
•
Install leveling feet as shown below.
NOTE: You may have to adjust leveling feet prior to
installing the completely assembled jointer/planer.
INSTALL
MOTOR
BRACKETS
Refer to Figures 1, 4, 5 and 6, pages 3, 4 and 5.
•
Identify and locate the following parts from the hard-
ware bag:
% 18 x 3/,"Carriage bolt (10)
,3/=. Rat washer (10)
'/=" Lockwasher (10)
s/,6"-18 Hex nut (10)
•
Identify and locate the following parts:
Lower motor bracket - K
Upper motor bracket - L
Vertical motor bracket - M
•
Install lower motor bracket across stiffners (Figure 4)
using four carriage bolts, ,3/=, flat washers, %" lock-
washers and 5/,6"-18hex nuts. Hand tighten hex nuts.
Switch Box
ped Holes
' Top Panel
Rgure 2 - Assemble Stand
_- Place the top panel on the floor upside down
•
Attach front and rear panels using the carriage bolts,
washers, hex nuts and stiffners (see Figure 2).
NOTE: Make sure that the front panel (with switch box)
is mounted opposite to four tapped holes in top panel.
INSTALL
LEVELING
FEET
Refer to Figure 3.
-"
•
Identify and locate the following parts from the hard-
ware bag:
:
Leveling Feet (4)
3/s" Flat washers (4)
3/,"-16 Hex nuts (8)
Figure 4 - Install Lower Motor Bracket
Attach vertical motor bracket to lower motor bracket
(Figure 5) using the slots on the lower motor bracket,
two carriage bolts, ,3/=, flat washers, %" Iockwashers
and 3113"-18 h ex nuts. Hand tighten hex nuts.
Figure 5 - Install Vertical Motor Bracket
4
Advertisement
