About The Original; Original Sizes; Originals That Can Be Faxed - Sharp AR-FX4 Operation Manual

ABOUT THE ORIGINAL

Originals that can be Faxed

Original sizes

In addition to the standard sizes (11" x 17", 8-1/2" x 14", 8-1/2" x 11", 8-1/2" x 11"R, 5-1/2" x 8-1/2", A4,
and A4R), originals within the following size range can also be faxed.
Using the SPF
Using the platen glass
*Long originals
Depending on the resolution setting and the width of the original, there may not be sufficient space in
memory to hold a long original. In this case, refer to the following table and select a lower resolution
setting and/or shorten the original.
Standard
Fine
Super fine
Ultra fine
Scanning area of originals
When faxing an original, note that the edges of the original cannot be scanned.
Area that cannot : Leading edge: (0.2") 5 mm or less
be scanned
: Trailing edge: (0.2") 5 mm or less
: Near side and far side: (0.24") 6 mm
or less
Automatic reduction of faxed originals
If you send a original of a larger width than the paper in the receiving fax machine, the original will be
automatically reduced.
G
You can turn off automatic reduction. In this case, the sides of the original will not be transmitted. (See
page 153)
Width of original
11" x 17"
Minimum original size
5-1/2" x 8-1/2"
11" wide
39.3"
39.3"
39.3"
34.6"
Paper size in receiving
machine
8-1/2" x 11"
Maximum original size
11" (width) x 39.3" (length)*
*Long originals can be loaded.
11" x 17"
8-1/2" wide
39.3"
39.3"
39.3"
39.3"
(unit : inch)
Far side
Leading
edge
Near side
Area that cannot be scanned
Size after reduction
8-1/2" x 11"R
Trailing
edge
Ratio
1 : 0.50 (Area ratio)
19
1