Table of Contents
Advertisement
Saving images
8
Select the folder in which the image is to be saved.
• All files are saved in JPEG format.
• If the "Details ..." button is clicked before pressing "Save"
button, the screen shown below is displayed and the
compression rate can be changed.
9
Click the "Save" button.
10
Repeat steps 6 to 8 to capture other images.
Exitting
11
To quit SV Photo Capture, click
With SV Photo Capture, the connection settings are set
automatically. These settings can also be set manually.
1) Click
.
2) Set the serial port and transfer speed.
3) Click "OK".
G Do not disconnect connection cables or turn off the power of the
Note
VIEWCAM, computer or other connected equipment while image
data is being transferred with SV Photo Capture. Doing so could
result in loss of important data stored on the computer's hard
disc.
.
5
CONTENTS
CONTENTS
PREVIOUS PAGE
PREVIOUS PAGE
VIEWCAM operation while SV Photo Capture
is running
• If still picture or slow playback is performed continuously for
a specific amount of time, the VIEWCAM automatically
switches back to playback to protect the video tape and
heads.
The power turns off after a specific amount of time if no
operation is performed while a tape is loaded when the
VIEWCAM is in the Tape Recording mode.
• The power does not turn off even after a specific amount of
time if no operation is performed during communications
between the VIEWCAM and SV Photo Capture in the Tape
Recording mode.
In the Tape Playback mode, the VIEWCAM goes into the
stop mode after still picture playback continues for a specific
amount of time.
NEXT PAGE
NEXT PAGE
Advertisement
Table of Contents
