Rs-232 Host Parameters - Motorola SYMBOL LS9203 Reference Manual

RS-232 Host Parameters

Various RS-232 hosts are set up with their own parameter default settings
A, Wincor-Nixdorf Mode B, Olivetti, Omron, or terminal sets the defaults listed below.
Standard
Parameter (Default)
Transmit Code ID No
Data Data as is
Transmission
Format
Suffix CR/LF (7013)
Baud Rate 9600
Parity None
Hardware None
Handshaking
Software None
Handshaking
Serial Response 2 Sec.
Time-out
Stop Bit Select One
ASCII Format 8-Bit
Beep On <BEL> Disable
RTS Line State Low
Prefix None
*In the Nixdorf Mode B, if CTS is Low, scanning is disabled. When CTS is High, the user can scan bar codes.
**If Nixdorf Mode B is scanned without the scanner connected to the proper host, it may appear unable to scan. If this happens, scan a different RS-232 host
type within 5 seconds of cycling power to the scanner.
Selecting the ICL, Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, OPOS, JPOS terminal enables the transmission of code
ID characters listed in Table below. These code ID characters are not programmable and are separate from the Transmit Code ID
feature. The Transmit Code ID feature should not be enabled for these terminals.
Table 6-2. Terminal Specific RS-232
ICL Fujitsu
Yes Yes
Data/Suffix Data/Suffix
CR (1013) CR (1013)
9600 9600
Even None
RTS/CTS Option 3 None
None None
9.9 Sec. 2 Sec.
One One
8-Bit 8-Bit
Disable Disable
High Low
None None
(Table ). Selecting the ICL, Fujitsu, Wincor-Nixdorf Mode
Wincor-Nixdorf Wincor-Nixdorf
Mode A Mode B/OPOS
Yes Yes
Data/Suffix Data/Suffix
CR (1013) CR (1013)
9600 9600
Odd Odd
RTS/CTS Option 3 RTS/CTS Option 3
None None
9.9 Sec. 9.9 Sec.
One One
8-Bit 8-Bit
Disable Disable
Low Low = No data to send
None None
RS-232 Interface 6-5
Olivetti Omron
Yes Yes
Prefix/Data/ Data/Suffix
Suffix
ETX (1002) CR (1013)
9600 9600
Even None
None None
Ack/Nak None
9.9 Sec. 9.9 Sec.
One One
7-Bit 8-Bit
Disable Disable
Low High
STX (1003) None