Set Lengths For Interleaved 2 Of 5 - Motorola SYMBOL LS9203 Reference Manual

Set Lengths for Interleaved 2 of 5

The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s) the code contains.
Lengths for I 2 of 5 may be set for any length, one or two discrete lengths, or lengths within a specific range.
When setting lengths for different bar code types by scanning single digit numbers, single digit numbers
must always be preceded by a leading zero.
Note
One Discrete Length - This option allows the scanner to decode only those I 2 of 5 symbols containing a selected length. Lengths
are selected from the numeric bar codes beginning on page
of 5 symbols with 14 characters, scan I 2 of 5 - One Discrete Length, then scan 1 followed by 4. If an error is made or to change
a selection, scan Cancel on page D-8.
Two Discrete Lengths - This option allows the scanner to decode only those I 2 of 5 symbols containing either of two selected
lengths. Lengths are selected from the numeric bar codes beginning on page
decode only those I 2 of 5 symbols containing either 2 or 14 characters, select I 2 of 5 - Two Discrete Lengths, then scan 0, 2,
1, and then 4. If an error is made or to change a selection, scan Cancel on page D-8.
D-1 in Appendix D, Numeric Bar
I 2 of 5 - One Discrete Length
D-1 in
I 2 of 5 - Two Discrete Lengths
Codes. For example, to decode only I 2
Appendix D, Numeric Bar Codes. For example, to
Symbologies 9-71