1. Manuals
  2. Brands
  3. AEG Manuals
  4. Refrigerator
  5. SDS51400S0
  6. User manual

AEG SDS51400S0 User Manual

Hide thumbs Also See for SDS51400S0:
Table of Contents

Advertisement

Quick Links

Download this manual
SDS51400S0
EN FRIDGE-FREEZER
USER MANUAL

Advertisement

Table of Contents
loading

Related Manuals for AEG SDS51400S0

Summary of Contents for AEG SDS51400S0

  • Page 1 SDS51400S0 EN FRIDGE-FREEZER USER MANUAL...
  • Page 2 AEG appliances looking spotless and working perfectly. Along with a wide range of accessories designed and built to the high quality standards you would expect, from specialist cookware to cutlery baskets, from bottle holders to delicate laundry bags… Visit the webshop at: www.aeg-electrolux.com/shop...

  • Page 3: Table Of Contents

    Contents CONTENTS 4 Safety information 6 Operation 7 First use 7 Daily use 8 Helpful hints and tips 9 Care and cleaning 11 What to do if… 13 Technical data 13 Installation 20 Environmental concerns The following symbols are used in this user manual: Important information concerning your personal safety and information...

  • Page 4: Safety Information

    Safety information SAFETY INFORMATION In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features.

  • Page 5: Care And Cleaning

    Safety information • It is dangerous to alter the specifications or modify this product in any way. Any dam- age to the cord may cause a short-circuit, fire and/or electric shock. WARNING! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel.

  • Page 6: Operation

    Operation • Adequate air circulation should be around the appliance, lacking this leads to overheat- ing. To achieve sufficient ventilation follow the instructions relevant to installation. • Wherever possible the back of the product should be against a wall to avoid touching or catching warm parts (compressor, condenser) to prevent possible burn.

  • Page 7: First Use

    First use • the location of the appliance. If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption.

  • Page 8: Helpful Hints And Tips

    Helpful hints and tips The numbers indicate storage times in months for the appropriate types of frozen goods. Whether the upper or lower value of the indicated storage time is valid depends on the quality of the foods and treating before freezing. Ice-cube production This appliance is equipped with one or more trays for the production of ice-cubes.

  • Page 9: Care And Cleaning

    Care and cleaning • only freeze top quality, fresh and thoroughly cleaned, foodstuffs; • prepare food in small portions to enable it to be rapidly and completely frozen and to make it possible subsequently to thaw only the quantity required; •...

  • Page 10: Defrosting Of The Refrigerator

    Care and cleaning Take care of not to damage the cooling system. Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. After cleaning, reconnect the equipment to the mains supply.

  • Page 11: What To Do If

    What to do if… 4. When defrosting is completed, dry the interior thoroughly. 5. Switch on the appliance. 6. After two or three hours, reload the previously removed food into the compartment. Never use sharp metal tools to scrape off frost from the evaporator as you could damage Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer.

  • Page 12: Replacing The Lamp

    What to do if… Problem Possible cause Solution The door is not closed correctly. Refer to "Closing the door". The door has been opened too Do not keep the door open lon- frequently. ger than necessary. The product temperature is too Let the product temperature de- high.

  • Page 13: Technical Data

    Technical data 3. Remove the lamp cover (refer to the il- lustration). 4. Replace the used lamp with a new lamp of the same power and specifically de- signed for household appliances. (the maximum power is shown on the lamp cover).

  • Page 14: Electrical Connection

    Installation Climate class Ambient temperature +10°C to + 32°C +16°C to + 32°C +16°C to + 38°C +16°C to + 43°C Electrical connection Before plugging in, ensure that the voltage and frequency shown on the rating plate cor- respond to your domestic power supply. The appliance must be earthed.

  • Page 15: Ventilation Requirements

    Installation 4. Loosen the middle hinge. 5. Remove the lower door. Loosen and remove the lower pin. On the opposite side: 1. Tighten the lower pin. 2. Install the lower door. 3. Tighten the middle hinge. 4. Install the spacer. 5.
  • Page 16 Installation Apply the adhesive sealing strip to the appliance as shown in figure. Install the appliance in the niche. Push the appliance in the direction of the arrow (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrow (2) against the cupboard on the opposite side of the hinge.
  • Page 17 Installation Attach the appliance to the niche with 4 screws. Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in opposite case. Attach the covers (C, D) to the lugs and the hinge holes.
  • Page 18 Installation Disconnect the parts (Ha), (Hb), (Hc) and (Hd). Install the part (Ha) on the inner side ca. 50 mm of the kitchen furniture. 90° 21 mm 90° ca. 50 mm 21 mm Push the part (Hc) on the part (Ha).
  • Page 19 Installation 10. Open the appliance door and the kitch- en furniture door at an angle of 90°. 8 mm Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. 11.

  • Page 20: Environmental Concerns

    Environmental concerns 13. Press the part (Hd) on the part (Hb). 14. To open the doors do these steps. Use the sliding system previously illus- trated or open one of the two doors by fitting the small handle supplied as an acces- sory.
  • Page 24 212720301-00-20052010...

Table of Contents