Motorola G24 Guide Developer's Manual page 68

AT Commands Summary
AT Command
M
N
P
T
Y
+FAR
+FCL
+FDD
+FIT
Fax Class 1
Fax Commands
+FCLASS
+FTS
+FRS
+FTM
+FRM
+FTH
+FRH
+IFC
+FPR
1-34
Table 1-1: AT Commands (Cont.)
Description
This command is supported for backward compatibility only, and
has no effect.
This command is supported for backward compatibility only, and
has no effect.
This command is supported for backward compatibility only, and
has no effect.
This command is supported for backward compatibility only, and
has no effect.
This command is supported for backward compatibility only, and
has no effect.
This command is supported for backward compatibility only, and
has no effect.
This command is supported for backward compatibility only, and
has no effect.
This command is supported for backward compatibility only, and
has no effect.
This command is supported for backward compatibility only, and
has no effect.
This command places the terminal in particular mode of operation
(data, fax, voice).
This command causes the G24 to stop any transmission.
This command causes the G24 to listen and to report back an OK
result code when the line has been silent for the specified amount of
time.
This command causes the G24 to transmit data.
This command causes the G24 to enter the receive mode.
This command causes the G24 to transmit data framed in the HDLC
protocol.
This command causes the G24 to receive HDLC framed data and
deliver the next received frame to the terminal.
This command controls the operation of the local flow control
between the terminal and the G24.
This command sets the request baud rate.
AT Commands Reference Manual
Page
Page 3-422
Page 3-422
Page 3-422
Page 3-422
Page 3-422
Page 3-423
Page 3-423
Page 3-423
Page 3-423
Page 3-424
Page 3-425
Page 3-425
Page 3-426
Page 3-428
Page 3-428
Page 3-430
Page 3-430
Page 3-432
December 31, 2007