Registering The Target Device With The Camera - Canon PowerShot SD430 Software & Wireless Manual

78
Wireless Network Settings for the Computer and Camera

Registering the Target Device with the Camera

Attach the camera to the computer using the interface cable and register the target device
(computer to be connected wirelessly) with the camera. Configure the settings using the
Camera Wireless Setup program (a wireless configuration utility). This step is only required the
first time you register a target device.
• The camera cannot connect wirelessly to computers that have not been
registered as target devices.
• The camera can register up to 7 devices.
A
Wireless Network Already in Use
B
1:1 Direct Connection between Camera and Computer
Both A and B
For Step 9 onward go to
Connection between Camera and Computer (p. 83).
1
A If your wireless network is already in use, confirm that the computer and router are
correctly connected and that the router's wireless settings are correctly configured.
B
If there is a 1:1 direct connection between the camera and computer, confirm
that the computer's wireless networking function is working.
2
Attach the supplied interface cable to the
computer's USB port and the camera's
DIGITAL terminal.
3
Turn on the camera and set it to the playback
mode.
The camera's
blue.
The Camera Control Window will appear on the
computer screen. Leave this window as is without
closing it.
share steps 1-8.
A Wireless Network Already in Use (p. 81) or
(Print/Share) button will light
B 1:1 Direct
Power Button
Playback
Mode