Dot1X Messages - Cisco IE-3000-8TC Message Manual

Chapter 2 Message and Recovery Procedures
Error Message DHCP_SNOOPING-6-VLAN_NOT_SUPPORTED: Vlan not supported. [dec] bindings
ignored.

DOT1X Messages

This section contains the IEEE 802.1x messages.
Error Message DOT1X-4-MEM_UNAVAIL: Memory was not available to perform the
802.1X action.
Error Message DOT1X-4-PROC_START_ERR: Dot1x unable to start.
Error Message DOT1X-4-UNKN_ERR: An unknown operational error occurred.
Error Message DOT1X-5-INVALID_INPUT: Dot1x Interface parameter is Invalid on
interface [chars].
OL-13020-01
Explanation The specified number of bindings were ignored when the switch read the database file
because the VLAN is no longer configured on the switch. [dec] is the number of bindings that the
switch ignores.
Recommended Action No action required.
The system memory is not sufficient to perform the IEEE 802.1x authentication.
Explanation
Reduce other system activity to reduce memory demands.
Recommended Action
The system failed to start the IEEE 802.1x process.
Explanation
Restart the IEEE 802.1x process by entering the dot1x system-auth-control
Recommended Action
global configuration command. If this message recurs, reload the device.
The IEEE 802.1x process cannot operate because of an internal system error.
Explanation
Reload the device.
Recommended Action
The IEEE 802.1x interface parameter is out of the specified range or is invalid. [chars]
Explanation
is the interface.
Refer to the CLI help documentation to determine the valid IEEE 802.1x
Recommended Action
parameters.
Cisco IE 3000 Switch System Message Guide
DOT1X Messages
2-11