Dot1X Messages - Cisco 3750 - Catalyst EMI Switch Message Manual

DOT1X Messages

DOT1X Messages
This section contains the 802.1x messages.
Error Message DOT1X-4-MEM_UNAVAIL: Memory was not available to perform the
802.1X action.
Error Message DOT1X-4-MSG_ERR: Unknown message event received.
Error Message DOT1X-4-PROC_START_ERR: Dot1x unable to start.
Error Message DOT1X-4-UNKN_ERR: An unknown operational error occurred.
Error Message DOT1X-5-ERR_CHANNELLING: Dot1x can not be enabled on Channelling
ports.
Error Message DOT1X-5-ERR_DYNAMIC: Dot1x can not be enabled on Dynamic ports.
Catalyst 3750 Switch System Message Guide
2-12
This message means that the system memory is not sufficient to perform the 802.1x
Explanation
authentication.
Reduce other system activity to reduce memory demands.
Recommended Action
This message means that the 802.1x process received an unknown message event.
Explanation
Recommended Action Restart the 802.1x process by entering the dot1x system-auth-control global
configuration command. If this message recurs, reload the device.
This message means that the system failed to create the 802.1x process.
Explanation
Recommended Action Restart the 802.1x process by entering the dot1x system-auth-control global
configuration command. If this message recurs, reload the device.
Explanation This message means that the 802.1x process cannot operate because of an internal
system error.
Recommended Action No action is required.
Explanation This message means that 802.1x could not be enabled on the channeling port. Trying to
set 802.1x port-control to auto or force-unauthorized (force_unauth) mode on a channeling port,
which is not allowed, caused this condition.
Disable channeling on the interface, and then enable 802.1x.
Recommended Action
This message means that 802.1x could not be enabled on the dynamic mode port. Trying
Explanation
to set 802.1x port-control to auto or force-unauthorized (force_unauth) mode on a dynamic mode
port, which is not allowed, caused this condition.
Disable dynamic mode on the interface, and then enable 802.1x.
Recommended Action
Chapter 2 Message and Recovery Procedures
78-16184-04