®
ProSafe
Dual Band Wireless-N Access Point
Technical Specifications
•
Standards
–
IEEE 802.11n, 2.4 GHz and 5.0 GHz
–
IEEE 802.11a 5.0 GHz
–
IEEE 802.11g, IEEE 802.11b, 2.4 GHz
–
IEEE 802.3ab Gigabit Ethernet
–
WMM - Wi-Fi Multimedia prioritization
–
Wireless Distribution System
–
IEEE 802.3af Power over Ethernet (PoE)
•
Physical Specifications
–
Dimensions: 32 x 190 x 124 mm
(1.25 x 7.5 x 4.9 in)
–
Weight: (.56 kg) 1.2 lb
–
Plenum rated
–
Flash: 16 MB
–
RAM: 128 MB
–
Slots for wall or ceiling mounting
•
Safety and Electromagnetic
Conformance
–
FCC Part 15 Subpart B and Subpart C
–
CE EN 60950, EN 300328-2 v1.1.1,
(2000-07), EMC EN 301489-1 v1.2.1,
(2000-08), and EN 301489-17 v1.1.1,
(2000-09), EN 55022(B), CISPR 22(B),
AS/NZS 3548(B)
•
Environmental Specifications
–
Operating temperature: 0° to 55° C
(32° to 131° F)
–
Operating humidity: 90% maximum
relative humidity, non-condensing
•
Physical Interfaces
–
One (1) 10/100/1000BASE-T Gigabit
Ethernet (RJ-45) port with Auto
Uplink™ (Auto MDI-X) with IEEE
802.3af Power over Ethernet (PoE)
support
–
Power adapter: 12V DC, 1A;
plug is localized to country of sale
–
Five (5) LEDs: Power, 10/100/1000
Mbps, Link/ACT, 2.4 GHz band,
5.0 GHz band
–
One (1) console port with standard
RS-232C interface with DB-9
male connector
350 East Plumeria Drive
San Jose, CA 95134 USA
1-888-NETGEAR (638-4327)
E-mail: info@NETGEAR.com
www.NETGEAR.com
–
Two (2) reverse SMA antenna
connectors for accessory antennas
Note: Not recommended for use with ProSafe Antennas
ANT2405, ANT2409 or ANT24D18
•
Power over Ethernet Required
–
Up to 12.8W
–
Typical Maximum Transmit Power: 20 dB
Note: Maximum Tx varies based on country and/or
region selection to ensure local regulatory compliance
•
Security
–
Wi-Fi Protected Access (WPA, WPA2)
–
Wired Equivalent Privacy (WEP) 64-bit,
128-bit encryption and 256-bit encryption
–
IEEE 802.1x RADIUS authentication
with EAP TLS, TTLS, PEAP
–
Wireless access control to identify
authorized wireless network devices
–
MAC address authentication ; up to
256 entries
–
VPN pass-through support
–
Secure SSH telnet
–
Secure Sockets Layer (SSL) remote
management login
–
Multiple SSID: 8 per band (16 total)
–
Block SSID Broadcast
–
VLAN Support: 17 VLAN
–
Rogue AP detection
–
Client isolation for Hotspot applications
–
Kensington locking slot for physical security
•
Network Management
–
Remote configuration and
management through Web browser,
SNMP or telnet with Command Line
Interface (CLI)
–
SNMP management supports SNMP
MIB I, MIB II, 802.11 MIB and
proprietary configuration MIB,
SNMP v1, V2c
•
Advanced Wireless Features
–
Point-to-point wireless bridge mode
–
Point-to-multipoint wireless
bridge mode
–
Repeater mode
–
Simultaneous wireless bridge and
access point mode
© 2009 NETGEAR, Inc. NETGEAR, the NETGEAR Logo, NETGEAR Digital Entertainer Logo, Connect with Innovation, FrontView, IntelliFi,
PowerShift, ProSafe, ProSecure, RAIDar, RAIDiator, RangeMax, ReadyNAS, Smart Wizard, X-RAID, and X-RAID2, are trademarks and/or
registered trademarks of NETGEAR, Inc. and/or subsidiaries in the United States and/or other countries. Mac and the Mac logo are trademarks
of Apple Inc., registered in the U.S. and other countries. Other brand names mentioned herein are for identification purposes only and may be
trademarks of their respective holder(s). Information is subject to change without notice. All rights reserved.
This product is packaged with a limited warranty, the acceptance of which is a condition of sale. This product has been tested for quality
assurance and this product or its components may have been recycled.
*Basic technical support provided for 90 days from date of purchase.
Maximum wireless signal rate derived from IEEE standard 802.11 specifications. Actual data throughput and wireless coverage will vary.
†
Network conditions and environmental factors, including volume of network traffic, building materials and construction, and network overhead,
lower actual data throughput rate and wireless coverage. NETGEAR makes no express or implied representations or warranties about this
product's compatibility with any future standards.
–
Wireless Distribution System (WDS)
–
Adjustable transmit power control
(TPC) from 100 mW down to 0 mW
–
WMM support for traffic prioritization
–
WMM-PS support for saving client
battery life
–
DHCP Server for clients
Warranty
–
Access point: ProSafe Lifetime
Warranty
–
Power supply: 3-year warranty
•
System Requirements
–
2.4 GHz/5 GHz 802.11n draft
specification adapter or 2.4 GHz
802.11b/g wireless adapter or 5 GHz
802.11a wireless adapter
–
Microsoft
Windows
Vista™, XP , 2000,
®
®
98, Me, Mac
OS, UNIX
®
®
–
Internet Explorer
6.0, Mozilla Firefox 1.5
®
–
We recommend using this product with
the RangeMax™ Dual Band Wireless
USB 2.0 Adapter (WNDA3100)
Package Contents
–
ProSafe Dual Band Wireless-N Access
Point (WNDAP350)
–
Ethernet cable
–
Wall-mount kit
–
Installation guide
–
Resource CD
–
12V, 1A power adapter, localized
to country of sale
Ordering Information
–
North America: WNDAP350-100NAS
–
Europe: WNDAP350-100PES
–
UK: WNDAP350-100UKS
–
Asia: WNDAP350-100AUS
ProSupport Service Packs
Available
•
OnCall 24x7, Category 1
–
PMB0331-100 (US)
–
PMB0331 (non-US)
•
XPressHW, Category 1
–
PRR0331
WNDAP350
, Linux
®
D-WNDAP350-0