Baumatic BFB230SL Instruction Manual page 27

o IMPORTANT: You must ensure that all of the hinge pins locate
into the relevant holes in the fridge and freezer doors. Also the
washers that fit over the hinge pins must also be present.
IMPORTANT: Check that both the upper and lower
doors open and shut correctly, without fouling, after
you have completed the door reversal process.
After the door has been reversed, you should check
the door seal of the fridge and freezer door. Neither
seal should be creased or crushed; otherwise there
will be a gap between it and the inside of the door.
o The seal must adhere properly all the way around the door.
o If either seal is not adhering to the cabinet properly, then you
should either:-
1. Use a warm damp cloth and manipulate the seal until it does
adhere to the cabinet properly, all the way around the door.
or
2. Use a hair dryer on its lowest heat setting and lightly heat the
areas of the door seal that are not adhering correctly. The
heat will make the seal more pliable and this will allow you to
manipulate the seal into the correct position.
IMPORTANT: DO NOT HEAT THE DOOR SEAL ON ANYTHING BUT
THE LOWEST HEAT SETTING, OR HEAT THE SEAL FOR A LONG
PERIOD OF TIME. OTHERWISE DAMAGE MAY BE CAUSED TO
THE DOOR SEAL, WHICH WOULD NOT BE RECTIFIED UNDER
THE GUARANTEE FREE OF CHARGE.
IMPORTANT: WHEN YOU HAVE REVERSED THE DOORS OF THE
APPLIANCE. AS YOU HAVE PLACED THE APPLIANCE ON ITS
SIDE, YOU MUST WAIT FOR 8 HOURS BEFORE SWITCHING THE
APPLIANCE BACK ON.
27