Baumatic BR200A User Manual page 13

To clean the condenser
1. Disconnect from the power supply.
2. Move the refrigerator out of its cabinet housing. TAKE EXTREME
CARE whilst performing this. The back of the appliance
consists of the condenser coils. These must be either dusted
lightly or vacuumed. Be careful not to damage them as they
are vital to the appliance's good functioning.
3. After cleaning, move the refrigerator back into place.
NOTE –
FROM TIME TO TIME, YOU
WILL ALSO NEED TO CLEAN
THE DRAIN PAN THAT SITS
ATOP THE COMPRESOR. Do
NOT remove it to clean it. IT
LOOKS LIKE THIS (at right):
DEFROSTING
during normal operation. The defrosted water
collected by the evaporating tray evaporates
automatically.
TIPS FOR ENERGY SAVINGS
Try not to open the door too often, especially when the
weather is wet and hot. Once you open the door, be sure
to close it as soon as possible.
Use higher thermostat settings only if essential and not
for constant, long-term use.
Before loading the appliance with packages of fresh foods,
ensure they are cooled to an ambient temperature.
If the door seal (gasket) is damaged, the energy
consumption will be much higher. To keep the sealing in
good condition, be sure not to spill oils or fats on it. A
damaged seal will need to be replaced.
CLEANING / MAINTENANCE
:
-
Defrosting occurs fully automatically
12