Wired Network - Dell 2135cn - Multifunction Color Laser Printer Troubleshooting Manual

Draft Mode
Purpose:
To save toner by printing in the draft mode. The print quality is reduced when printing in the draft mode.
Values:
Disable* Does not print in the draft mode.
Enable Prints in the draft mode.
LineTermination
Purpose:
To add the line termination commands.
Values:
The line termination command is not added.
Off*
CR=CR, LF=LF, FF=FF
The LF command is added.
Add-LF
CR=CR-LF, LF=LF, FF=FF
The CR command is added.
Add-CR
CR=CR, LF=CR-LF, FF=CR-FF
The CR and LF commands are added.
CR-XX
CR=CR-LF, LF=CR-LF, FF=CR-FF
Default Color
Purpose:
To specify the color mode to Color or Black. This setting is used for a print job which does not specify a print mode.
Value:
Black* Prints in the black and white mode.
Color Prints in the color mode.

Wired Network

Use the Wired Network menu to change the printer settings affecting jobs sent to the printer through the wired network.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Ethernet
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change becomes effective after the printer is turned off and then on again.
Values:
Auto* Detects the Ethernet settings automatically.
10Base Half Uses 10base-T half-duplex.
10Base Full Uses 10base-T full-duplex.
100Base Half Uses 100base-TX half-duplex.
100Base Full Uses 100base-TX full-duplex.
TCP/IP
Purpose: