Sched Messages; Spantree Messages - Cisco 3845 - Security Bundle Router Manual

Chapter 2 Messages and Recovery Procedures

SCHED Messages

Error Message SCHED-3-UNEXPECTEDEVENT: [traceback] [process information] Process
received unknown event (maj [hex], min [hex])
Explanation
[hex] is the minor event number.

SPANTREE Messages

Error Message SPANTREE-2-BLOCK_BPDUGUARD_VP: Received BPDU on port [chars], vlan
[dec] with BPDU Guard enabled. Disabling vlan.
Error Message SPANTREE-2-BLOCK_PVID_LOCAL: Blocking [chars] on [chars]. Inconsistent
local vlan.
OL-23408-01
An event was not processed. The first [hex] is the major event number, and the second
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the
page 1-5.
ABridge Protocol Data Unit (BPDU) was received on an interface and a VLAN . The
Explanation
spanning tree BPDU guard feature was enabled and configured to shut down the VLAN. The VLAN
was placed in the error-disabled state. [chars] is the interface, and [dec] is the VLAN.
Either remove the device sending BPDUs or disable the BPDU guard feature.
Recommended Action
You can configure the BPDU guard feature either locally on the interface or globally on all ports
enabled with Port Fast. Enter the clear errdisable privileged EXEC command to re-enable the
interface and VLAN.
Explanation The spanning-tree port associated with the listed spanning-tree instance and interface
will be held in the spanning-tree blocking state until the port VLAN ID (PVID) inconsistency is
resolved. The listed spanning-tree instance is that of the native VLAN ID of the listed interface. The
first [chars] is the interface, and the second [chars] is the spanning-tree instance.
Recommended Action Verify that the configuration of the native VLAN ID is consistent on the
interfaces on each end of the 802.1Q trunk connection. When corrected, spanning tree automatically
unblocks the interfaces, as appropriate.
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
"Error Message Traceback Reports" section on
SCHED Messages
2-57