Editing Ppp Options - NETGEAR RH348 Reference Manual

Reference Guide for the Model RT328 and Model RH348 ISDN Routers
Table 5-1. Menu 11.1 Remote Node Profile Fields (continued)
Field
Session Options:
Output Filter Sets
Call Filter Sets
Idle Timeout (sec)

Editing PPP Options

To edit PPP options:
Select Yes in the Edit PPP Options field of Submenu 11.1 - Remote Node Profile.
1.
Press [Enter] to display Menu 11.2 Remote Node PPP Options.
2.
Edit the options described in Table 5-2.
3.
Press [Enter] at the Press ENTER to Confirm... prompt to confirm your selections, and
4.
return to the previous menu.
Press [Esc] at any time to cancel your selections.
Continue to the end of Menu 11.1 and press [Enter] to save the selections you made in
5.
Menu 11.2.
5-4
Description
In these fields, select which filter set(s) you would like to implement to filter the
incoming and outgoing traffic between this remote node and the router. You can
choose from 12 different filter sets. In addition, you can link up to 4 filter sets
together for further customization (for example, 1, 5, 9, 12). Spaces and commas
are accepted in this field. The default is blank (no filters are defined). Refer to
Chapter 8, "Filter Configuration," for more information about configuring filters.
This value specifies the number of idle seconds elapsed before the remote node is
automatically disconnected. Idle seconds is the period of time where no data is
passed between the remote node and your router. Administrative packets such as
RIP are not counted as data. The default is 300 seconds (5 minutes).
Remote Node Configuration