Management and Configuration
This section provides an overview of all management and configuration facilities that are provided by
the Cisco VG30D Voice Gateway's Gateway Management Interface. Refer to the
Interface
Gateway
Set IP Address
You should have established the Cisco VG30D Voice Gateway's IP Addresses and Subnet Masks during
the initial setup process. However, you can change these addresses at any time and also insert a Default
Gateway IP Address. Leaving the Default Gateway IP Address field blank signifies that no default
gateway is to be used.
You can also give the Cisco VG30D Voice Gateway a Gateway Name, which will display beneath the
IP address at the bottom of the Gateway Management Interface configuration pages.
IP Address changes will not be effected until the Cisco VG30D Voice Gateway has been reset. You will
need to log in to the new address for any further configuration changes. Name changes take effect
immediately.
Set Time & Date
You can set the time and date by entering them into the fields that are provided. You can do this by
accepting the values that are displayed or by synchronising them with your computer.
Set PCM Clock Source
You can set Clock Synchronization to Port 1 or Port 2
Configure SNMP Traps
You can enable up to eight Trap Destination Addresses by inserting the address value. To disable an
address, remove the address value.
OL-19276-01
section.
4
C H A P T E R
Cisco VG30D Voice Gateway User Guide
Gateway Management
4-1