Connection Sequence; Front Panel Indicators; Status; Lan - Cisco VG30D User Manual

Chapter 2 Installation

Connection Sequence

To identify the ports, refer to
Do not connect to the E1 telephony ports until first-time configuration is complete.
Caution
Connect the earthing cable as described in the "Caution" in
Step 1
Step 2 Connect the mains power cable.
Step 3 Connect the 10/100 Ethernet cable.

Front Panel Indicators

The Cisco VG30D Voice Gateway unit has 10 LEDs on its front panel. They show unit status information.
This section describes the front panel indicators that
Figure 3

STATUS

The 4 red STATUS LEDs are labelled S3, S2, S1, and S0. They indicate unit status in conjunction with
the two port LEDs, P1 and P2. During unit self-test, the status LEDs will come on and go off in sequence,
and in the event of a self-test failure, stop with one LED remaining on.

LAN

Three LEDs indicate LAN activity. The TxD LED flashes amber on transmission of a packet. The
Link/RxD LED flashes green on receipt of a packet. The green Speed LED is ON for 100 Mbit/s or OFF
for 10Mbit/s. If Ethernet is not connected, these LEDs will remain off.
The RxD LED will flash for any traffic on the Ethernet, regardless of destination.
Note
OL-19276-01
Figure 4.
Front View
Port Active
LEDs
STATUS LAN
P1
Status of Local Area
active port Network
LEDs LEDs
Hardware
Figure 3 shows.
P2 Power
Power LED
(Amber in self
test, Green when
operational)
Cisco VG30D Voice Gateway User Guide
Connection Sequence
Installation.
Cisco VG30D
2-3