Management - Cisco VG30D User Manual

Chapter 1 Introduction
Figure 1-2
Conversions operate on the common signalling channel only. Bearer circuits get passed directly through
the unit. You can configure each protocol support to meet specific application needs.
You can configure the Virtual Private Network protocol support to operate into sub-equipped ISDN
trunks, which allows the user to maximise the benefits of the advantageous Primary Rate ISDN tariffs
now that are being offered by some PTOs.
The Cisco VG30D Voice Gateway also provides some additional facilities:
•
•
•
•

Management

On powering on the Cisco VG30D Voice Gateway, Power On Self Test gets performed. You can monitor
the process using the Craft port and the serial cable that is supplied with the Cisco VG30D Voice
Gateway. See
After this self test is complete, achieve configuration and management of the Cisco VG30D Voice
Gateway's signalling functions by using the Gateway Management Interface and a Web browser on a
networked computer. See
Factory default settings were installed during manufacturing. For any advanced engineering support
under the guidance of a Cisco Systems, Inc., support engineer, an additional cable will be required (Find
details in
OL-19276-01
Cisco VG30D Voice Gateway in a CPE
DPNSS
PBX
The ability to perform diversions on behalf of the PBX
Support for the Q.932 redirecting number element for diversion
Custom configuration for Cisco Unified Communications Manager and other PBXs
The ability to display DPNSS Message Waiting Indications on telephones that are controlled by
Cisco Unified Communications Manager
Power On Self Test and IP Address
Initial Configuration
Craft Port - Factory
Cisco VG30D
VG30D
Gateway
Setup.
and Management and
Mode.)
QSIG/Q.931
QSIG/Q.931
Configuration.
Cisco VG30D Voice Gateway User Guide
Management
1-3