Dell PowerEdge M420 Reference Manual page 1438

Parameter Description
Parameter
dual-ipv4-and-ipv6
ipv4-routing
Default Configuration
The system defaults to the dual IPv4 and IPv6 template.
Command Mode
Global Config
User Guidelines
SDM templates enable you to reallocate system resources to support a
different mix of features. After setting the template, you must reboot in order
for the configuration change to take effect.
If you attach a unit to a stack and its template does not match the stack's
template, then the new unit will automatically reboot using the template
used by other stack members. To avoid the automatic reboot, you may first
set the template to the template used by existing members of the stack. Then
power off the new unit, attach it to the stack, and power it on.
The following table lists the completion messages.
Message Type
Successful
Completion
Message
1434
SDM Templates Commands
Description
This keyword filters subsequent template choices to those that
support both IPv4 and IPv6. There is only one such template. It
is selected using the keyword default.
This keyword filters subsequent template choices to those that
support IPv4 and not IPv6. The default IPv4-only template
maximizes the number of IPv4 unicast routes, while limiting
the number of ECMP next hops in each route to 4. The data-
center template supports increases the number of ECMP next
hops to 16 and reduces the number of routes.
Message Description
Changes to the running SDM preferences have been stored, but
cannot take effect until the next reload. Use the show sdm
prefer command below to see what SDM preference is currently
active.