Response Status Code Handling Section - Cisco Small Business SPA2102 Administration Manual

ATA Voice Field Reference
SIP page
Cisco Small Business ATA Administration Guide
Reg Retry Long
Intvl
Reg Retry Random
Delay
Reg Retry Long
Random Delay
Reg Retry Intvl Cap The maximum value to cap the exponential back-off retry
Voice tab > SIP page >

Response Status Code Handling section

SIT1 RSC
SIT2 RSC
SIT3 RSC
When registration fails with a SIP response code that does
not match
Retry Reg RSC
, the ATA device waits for the specified
length of time before retrying. If this interval is 0, the ATA
device stops trying. This value should be much larger than
the Reg Retry Intvl value, which should not be 0.
The default is 1200.
Random delay range (in seconds) to add to
Intvl when retrying REGISTER after a failure.
The default is 0, which disables this feature.
Random delay range (in seconds) to add to
Long Intvl
when retrying REGISTER after a failure.
The default is 0, which disables this feature.
delay (which starts at
every REGISTER retry after a failure). In other words, the
retry interval is always at
a failure. If this feature is enabled,
is added on top of the exponential back-off adjusted delay
value.
The default value is 0, which disables the exponential back-
off feature.
SIP response status code for the appropriate Special
Information Tone (SIT). For example, if you set the SIT1 RSC
to 404, when the user makes a call and a failure code of
404 is returned, the SIT1 tone is played. Reorder or Busy
tone is played by default for all unsuccessful response
status code for SIT 1 RSC through SIT 4 RSC.
SIP response status code to INVITE on which to play the
SIT2 Tone.
SIP response status code to INVITE on which to play the
SIT3 Tone.
Register Retry Intvl
and doubles on
Register Retry Intvl
Reg Retry Random Delay
B
Register Retry
Register Retry
seconds after
131