Cisco WAVE-574-K9 - Wide Area Virtualization Engine 574 Hardware Installation Manual page 86

Power-On Self Test (POST)
Fatal Express Port Error
Fatal Front Side Bus Error
Fatal Global Protocol Error
Fatal Hub Link Error
FATAL ROM ERROR: The System ROM is not Properly Programmed.
Fibre Channel Mezzanine/Balcony Not Supported.
High Temperature Condition detected by Processor X
Cisco Wide Area Virtualization Engine 574 Hardware Installation Guide
6-16
Possible Cause: A PCI Express port has experienced a fatal error that caused an
NMI.
Action: Reseat any loose PCI Express boards. If the problem persists, contact the
Cisco Technical Assistance Center.
Possible Cause: The processor front-side bus experienced a fatal error.
Action: Reseat any loose processors. If the problem persists, contact the Cisco
Technical Assistance Center.
Possible Cause: The system experienced a critical error that caused an NMI.
Action: If the problem persists, contact the Cisco Technical Assistance Center.
Possible Cause: The hub link interface has experienced a critical failure that
caused an NMI.
Action: If the problem persists, contact the Cisco Technical Assistance Center.
Possible Cause: The System ROM is not properly programmed.
Action: If the problem persists, contact the Cisco Technical Assistance Center.
Description: The Fibre Channel adapter is not supported on the WAVE appliance.
Action: Install the supported Fibre Channel adapter.
Possible Cause: Ambient temperature exceeds recommended levels, fan solution
is insufficient, or fans have failed.
Chapter 6 Troubleshooting the System Hardware
OL-17738-01