Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual page 113

Chapter 6 Troubleshooting the System Hardware
Table 6-9 Error Code Definitions (continued)
Error Code Problem
202-XXX-00n Failed system cache test.
n = APIC ID for failing
microprocessor:
•
•
215-XXX-000 Failed CD-RW/DVD drive test.
217-198-XXX Could not establish drive
parameters.
217-XXX-00n Failed fixed disk test.
n is the number of the failed
drive. The hard disk drive
numbers are on the front bezel.
301-XXX-000 Failed keyboard
After installing a USB keyboard,
you might have to use the
Configuration/Setup Utility
program to enable keyboardless
operation and prevent the POST
error message 301 from being
displayed during startup.
OL-15012-02
0, 1, 2, 3 = microprocessor 1
4, 5, 6, 7 = microprocessor 2
2
test.
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
Action
Reflash or update firmware to the latest
1.
level.
Check VRM if n = 4, 5, 6, or 7.
2.
Check the indicated microprocessor.
3.
Run the test again with a different
1.
CD-RW/DVD drive.
Reseat the CD-ROM drive.
2.
Reseat the operator information panel
3.
assembly.
Check the hard disk drive signal cable.
1.
2. Reseat the hard disk drive.
Check the hard disk drive backplane.
3.
Check the hard disk drive.
4.
Reseat the hard disk drive indicated by n.
1.
Replace the hard disk drive indicated by n.
2.
Reseat the keyboard cable.
1.
Check the system board.
2.
Symptoms and Solutions
6-39