Cisco AJ732A - MDS 9134 Fabric Switch Release Note page 61

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
CSCsk35725
•
Symptom: Fabric Manager takes 2 to 3 minutes to bring up the DMM job creation wizard in a setup
with 25 switches, 400 enclosures, and 2400 entries in the name server.
Workaround: None.
CSCsk49309
•
Symptom: IPv6 duplicate address detection (DAD) may not always works for the management port.
Workaround: None.
CSCsm47252
•
Symptom: DMM jobs move to the Reset state and the following reason is displayed:
failure
communicate with each other over IP by establishing a TCP connection. This connection is routed IP over
FC to the local Supervisor and from the Supervisor it is switched over the IP mgmt interface. As a result,
if there is a Supervisor switchover, the TCP connection may or may not survive the switchover. In the
event that the TCP connection cannot be re-established in time, the DMM jobs in that SMM will move
to the Reset state.
Workaround: None.
CSCsq20408
•
Symptom: The show startup command displays aspects of the running configuration when SANtap
is configured and/or SANtap objects are created. When a user creates objects such as a CVT or DVT,
the configuration is showing in the running-configuration and in the startup-configuration without
copying the configuration into the startup-configuration.
Workaround: Issue a copy running-config startup-config command whenever you create objects
such as a CVT or DVT so that the running-configuration and startup-configuration are synchronized.
• CSCsr69166
Symptom: Solaris Windows Manager does not resize windows correctly which effects some Device
Manager screens.
Workaround: Download and install the 119538-1 patch from Sun Microsystems. The patch
(119538-17 GNONE 2.6.0: Windows Manager Patch, Generic, 2008/08/08) can be obtained from
sunsolve.sun.com.
CSCsu30034
•
Symptom: During and In Service Software Upgrade (ISSU), throughput statistics will not be
available from the switch undergoing an upgrade. This information will be not able available from
the CLI or Device Manager via SNMP.
Workaround: After the upgrade is complete, the statistics will become available.
CSCsu39975
•
Symptom: Device Manager does not install and the system displays this error:
[ERROR] no !/ in spec
This issue occurs in Fabric Manager and Device Manager Release 3.2(x), Release 3.3(x), Release
3.4(x), and Release 4.1(x).
Workaround: Uninstall JRE 1.5_16 and install any other JRE 1.5 update if you intend to use Device
Manage Release 3.2(x). Use JRE 1.6 with Device Manager Release 3.3(x), Release 3.4(x) and
Release 4.1(x).
OL-17675-02
. In a Cisco DMM dual-fabric topology, the Storage Service Module (SSMs) in the two fabrics
Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.1(1b)
Caveats
Peer connection
61