Cisco AJ732A - MDS 9134 Fabric Switch Release Note page 58

Cisco mds 9000 family release notes for cisco mds nx-os release 4.1(1b) (ol-17675-02, october 2008)
Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
Table of Contents

Advertisement

Caveats
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Workaround: This issue is resolved.
CSCsi56167
Symptom: The response time shown in the output of a ping ip-address command may not be accurate
if there is an MDS MSM-18/4 in the path.
Workaround: This issue is resolved.
CSCsq12364
Symptom: You cannot see information about the default access list for the management interface
(mgmt0), which is applied by the system to the management interface (mgmt0) in the absence of any user
access list.
Workaround: This issue is resolved.
CSCsq23132
Symptom: The snmp-server enable trap command does not support the capability to enable or
disable traps from the CISCO-VSAN-MIB.
Workaround: This issue is resolved.
CSCsq94831
Symptom: Typing the IP address of the Nexus 5020 switch into the browser address bar shows a
download page which says Cisco Device Manager for MDS 9000 Series
Workaround: This issue is resolved.
CSCsk90998
Symptom: The signal loss counters in the output of the show interface fcx/y command are not
incremented.
Workaround: This issue is resolved.
CSCsm44119
Symptom: When an IVR zone is configured, IVR checks the zone member's native VSAN with the
following compatibility:
1. Interop mode— If the member's native VSAN is Interop mode, a READ-Only zone is configured,
and an error message is displayed on the initiating MDS 9000 switch, then the configuration fails.
2. The QoS attribute is in an IVR zone set.
3. Enhanced zoning and LUN zoning is in the IVR zone set.
4. There is a dash in the IVR zone name.
Workaround: This issue is resolved.
CSCso32705
Symptom: Disabling Fabric Manager e-mails for Call Home on a port flap event through the server
properties is not allowed.
Workaround: This issue is resolved.
CSCsr04936
Symptom: Some explanatory logs may be lost if a Supervisor module is reset with the reason "Reset
Requested due to Fatal Module Error".
Workaround: This issue is resolved.
Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.1(1b)
58
OL-17675-02

Advertisement

Table of Contents
loading

Table of Contents