Cisco AJ732A - MDS 9134 Fabric Switch Release Note page 18

Upgrading Your Cisco MDS NX-OS Software Image
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Copy the Fabric Manager jar file m9000-fm-4.1.1b.jar from the CD-ROM to a folder on the Solaris
Step 3
workstation.
Step 4 Launch the installer using the following command:
Follow the onscreen instructions provided in the Fabric Manager management software setup wizard.
Step 5
Installing Fabric Manager on Windows
This section describes how to install Fabric Manager on Windows.
Fabric Manager Server can not be installed on an Active Directory Server when using PostgreSQL,
Note
Fabric Manager servers are domain controllers and can not create local PostgreSQL user accounts.
If your server is running Terminal Services in Application mode, or if you are running Citrix Metaframe
or any variation thereof, you need to issue the following command on the DOS prompt before installing
Fabric Manager Server.
To install Fabric Manager on Windows, follow these steps:
Click the Install Management Software link.
Step 1
Choose Management Software > Cisco Fabric Manager.
Step 2
Click the Installing Fabric Manager link.
Step 3
Step 4 Select the drive for your CD-ROM.
Step 5 Click the FM Installer link.
Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.1(1b)
18
java -Xms512m -Xmx512m -jar m9000-fm-4.1.1b.jar
Open a command-line prompt: Start > Run, then type cmd and press Return.
1.
At the command prompt type: user /install.
2.
Do not close the command line window. This must remain open for the entire duration
Note
of the install.
The following is an example of the output of this command:
C:\Documents and Settings\user.domain>USER /INSTALL
User session is ready to install applications.
3. Follow all steps needed to install Fabric Manager, Fabric Manager Server, and Device Manager.
See the instructions later in this section.
4. When the installation is complete, at the command prompt, type user /execute and press
Return. Then type exit and press Return.
The following is an example of the output of this command:
C:\Documents and Settings\user.domain>USER /execute
User session is ready to execute applications.
OL-17675-02