Maytag MED9700S - Electric Dryer Use And Care Manual page 13

Strip 5" (12.7 cm) of outer covering from end of cable, leaving bare ground wire at 5"
(12.7 cm). Cut 11/2" (3.8 cm) from 3 remaining wires. Strip insulation back 1" (2.5 cm). Shape
ends of wires into a hook shape.
1"
When connecting to the terminal block, place the hooked end of the wire under the screw of
the terminal block (hook facing right), squeeze hooked end together and tighten screw, as
shown.
1.
2.
Remove center silver-colored terminal block screw.
Remove neutral ground wire from external ground conductor screw. Connect neutral
ground wire and place the hooked end (hook facing right) of the neutral wire (white or
center wire) of direct wire cable under the center screw of the terminal block. Squeeze
hooked ends together. Tighten screw.
Connect ground wire/green or bare) of direct wire cable to external ground conductor
screw. Tighten screw.
A. External ground conductor screw
B. Ground wire" (green or bare') of power supply cable
C. _" ( 1.9 cm) UL li_ted strain relie'f
D. C_ulter silver-colored terminal block scre'w
E. Neutral groutld wire"
f. Neutral wire twhite or cente'r wire)
Place the hooked ends of the other direct wire cable wires under the outer terminal [)lock
screws
(hooks
facing right). Squeeze hooked ends together. Tighten screws.
!! !!
5. Tighten strain relief screw.
6. insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-
down screw.
7. You have completed your electrical connection. Now go to "Venting Requirements."
A. Yxternal ground conductor scre'w - Dotte'd line shows position of NEUTRAL
ground wire before" being n'loved to center silver-colored te'rP,'linal block screw.
B. C_'nter silver-colored te'rn'linal block screw
C. Neutral ground wire'
D. Neutral wire' (white or center wire')
E. Y#" (1.9 cm) UL listed strain reqief