Remote Control - Sharp Aquos AN-ACS1U Operation Manual

Remote control

Battery installation
1
Open the battery cover.
2
Insert the batteries according to the direction
indicated in the battery compartment.
3
Close the cover.
Test of the remote control
Remote sensor
Approx.
20cm (8 in.)
to 6m (20 ft.)
Open
Insert battery with
side first
Close
Approx. Approx.
15º 15º
Precautions for battery use:
• Replace all old batteries with new ones at the same time.
• Do not mix old and new batteries.
• Remove the batteries if the unit will not be used for long periods of
time. This will prevent potential damage due to battery leakage.
Caution:
• Do not use rechargeable batteries (nickel-cadmium battery, etc.).
• Installing the batteries incorrectly may cause the unit to malfunction.
Point the remote control directly at the remote sensor on the
main unit.
The remote control can be used within the range shown left.
NOTE
• If the power does not come on, check whether the power cord is
properly plugged in and whether the batteries have been inserted
correctly into the remote control.
• Replace the batteries if the operating distance is reduced or if the
operation becomes erratic.
Purchase 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar).
• Periodically clean the transmitter on the remote control and the
sensor on the unit with a soft cloth.
• Exposing the sensor on the unit to strong light may interfere with
operation. Change the lighting or the direction of the unit.
• Keep the remote control away from moisture, heat, shock, and
vibrations.
17