Table of Contents
Advertisement
When performing operation of multiple monitors with the
remote control unit, first set the remote control unit to the
appropriate remote control mode (see page 21).
2
5
7
8
TIPS
• You can perform operation of the monitor with the rear
buttons. Utilize the buttons belonging to the monitor that
you would like to operate.
• Operation by using the buttons on the rear side of the
product will perform the same functions.
Rear side buttons
Remote control
unit buttons
This manual assumes that this product will be used with
the remote control unit buttons, except where specifically
noted.
18
E
Basic Operation
1. INPUT (Input mode selection)
The menu is displayed. Press
mode, and press
Input mode
PC D-SUB
1
PC HDMI
AV HDMI
When the PN-ZB02 (optional) is attached
3
Input mode
4
PC DVI-D
PC HDMI
PC D-SUB
PC RGB
AV DVI-D
AV HDMI
AV COMPONENT AV component input terminals
6
AV S-VIDEO
AV VIDEO
*1 Select the terminal to be used in HDMI of INPUT SELECT.
(See page 26.)
*2 Select the terminal for AUDIO SELECT which is used for
audio input. (See page 26.)
*3 Select the terminal to be used in DVI of INPUT SELECT.
(See page 26.)
*4 Select the terminal to be used in BNC of INPUT SELECT.
(See page 26.)
2. MUTE
Turns off the volume temporarily.
Press the MUTE button again to turn the sound back to the
previous level.
If using the monitor buttons, either hold both
same time or select MUTE AUDIO from the OPTION menu.
3. MENU
Displays and turns off the menu screen (see page 22).
4. VOL +/- (Volume adjustment)
Pressing
menu screen is not displayed.
Press
* If you do not press any buttons for about 4 seconds, the
VOLUME menu automatically disappears.
or
to enter.
Video
PC D-sub input terminal
PC/AV HDMI input terminal
PC/AV HDMI input terminal
Video
PC/AV DVI-D input terminal
PC/AV HDMI input terminal
PC D-sub input terminal
PC RGB input terminals
*4
PC/AV DVI-D input terminal
PC/AV HDMI input terminal
AV S-video input terminal
AV video input terminal
or
displays the VOLUME menu when the
V O L U M E
15
or
to adjust the volume of the sound.
to select the input
Audio
Audio input terminal
*1
*2
*1
Audio
*3
*1
*3
*2
*1
*4
and
at the
Advertisement
Table of Contents
