Computers Set To Dhcp; Manually Setting Up Your Modem Router - NETGEAR DM111P - ADSL2+ Ethernet Modem Setup Manual

Computers Set to DHCP

For the initial connection to your router, your computer has to be set to automatically get its
TCP/IP configuration from the router via DHCP. This is usually the case. The NETGEAR Smart
Wizard CD automatically takes care of this requirement. For manual setup, refer to the
documentation that came with your computer.

Manually Setting Up Your Modem Router

There are four steps to setting up your modem router:
1. Install ADSL filters on the phone lines.
Connect the modem router to the ADSL line.
2.
Log in to the modem router.
3.
Connect to the Internet.
4.
Follow the steps below to connect your router to your network. Before you begin, locate the ADSL
configuration information from your Internet Service Provider (ISP).
1. Connect the ADSL filter.
If you purchased the modem router in a country where an ADSL filter is not
included, you must acquire one.
a. You need to install an ADSL filter for every telephone that uses the same phone line as
your modem router. Select the filter that came with your modem router.
1
3
1. One-Line Filter: Use with a phone or fax machine.
2. Splitter: Use with a one-line filter to share an outlet with a phone and the modem router
3. Two-Line Filter with Splitter: Use to share an outlet with a phone and the modem router
Figure 6
8
2
Connecting the Router to the Internet
.
.