Default Ethernet Vlan Configuration; Creating Or Modifying An Ethernet Vlan - Cisco WS-CBS3032-DEL Software Configuration Manual

Configuring Normal-Range VLANs

Default Ethernet VLAN Configuration

Table 13-2
The switch supports Ethernet interfaces exclusively. Because FDDI and Token Ring VLANs are not
Note
locally supported, you only configure FDDI and Token Ring media-specific characteristics for VTP
global advertisements to other switches.
Table 13-2
Parameter
VLAN ID
VLAN name
IEEE 802.10 SAID
MTU size
Translational bridge 1
Translational bridge 2
VLAN state
Remote SPAN
Private VLANs

Creating or Modifying an Ethernet VLAN

Each Ethernet VLAN in the VLAN database has a unique, 4-digit ID that can be a number from 1 to
1001. VLAN IDs 1002 to 1005 are reserved for Token Ring and FDDI VLANs. To create a normal-range
VLAN to be added to the VLAN database, assign a number and name to the VLAN.
With VTP version 1 and 2, if the switch is in VTP transparent mode, you can assign VLAN IDs greater
Note
than 1006, but they are not added to the VLAN database. See the
VLANs" section on page
For the list of default parameters that are assigned when you add a VLAN, see the
Normal-Range VLANs" section on page
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
13-8
shows the default configuration for Ethernet VLANs.
Ethernet VLAN Defaults and Ranges
Default
1
VLANxxxx, where xxxx
represents four numeric digits
(including leading zeros) equal
to the VLAN ID number
100001 (100000 plus the
VLAN ID)
1500
0
0
active
disabled
none configured
13-11.
Range
1 to 4094.
Extended-range VLANs (VLAN
Note
IDs 1006 to 4094) are not saved in
the VLAN database.
No range
1 to 4294967294
1500 to 18190
0 to 1005
0 to 1005
active, suspend
enabled, disabled
2 to 1001, 1006 to 4094.
"Configuring Extended-Range
13-4.
Chapter 13 Configuring VLANs
"Configuring
OL-13270-06