Adding And Removing Static Address Entries - Cisco WS-CBS3032-DEL Software Configuration Manual

Managing the MAC Address Table
Command
Step 3
snmp-server enable traps mac-notification threshold
Step 4
mac address-table notification threshold
Step 5
mac address-table notification threshold [limit
percentage] | [interval time]
Step 6
end
Step 7 show mac address-table notification threshold
show running-config
Step 8 copy running-config startup-config
To disable MAC address-threshold notification traps, use the no snmp-server enable traps
mac-notification threshold global configuration command. To disable the MAC address-threshold
notification feature, use the no mac address-table notification threshold global configuration
command.
This example shows how to specify 172.20.10.10 as the NMS, enable the MAC address threshold
notification feature, set the interval time to 123 seconds, and set the limit to 78 per cent.
Switch(config)# snmp-server host 172.20.10.10 traps private mac-notification
Switch(config)# snmp-server enable traps mac-notification threshold
Switch(config)# mac address-table notification threshold
Switch(config)# mac address-table notification threshold interval 123
Switch(config)# mac address-table notification threshold limit 78
You can verify your settings by entering the show mac address-table notification threshold privileged
EXEC commands.

Adding and Removing Static Address Entries

A static address has these characteristics:
•
•
•
You can add and remove static addresses and define the forwarding behavior for them. The forwarding
behavior defines how a port that receives a packet forwards it to another port for transmission. Because
all ports are associated with at least one VLAN, the switch acquires the VLAN ID for the address from
the ports that you specify. You can specify a different list of destination ports for each source port.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
5-20
It is manually entered in the address table and must be manually removed.
It can be a unicast or multicast address.
It does not age and is retained when the switch restarts.
Chapter 5
Purpose
Enable the switch to send MAC threshold
notification traps to the NMS.
Enable the MAC address threshold notification
feature.
Enter the threshold value for the MAC address
threshold usage monitoring.
• (Optional) For limit percentage, specify the
percentage of the MAC address table use; valid
values are from 1 to 100 percent. The default is
50 percent.
(Optional) For interval time, specify the time
•
between notifications; valid values are greater
than or equal to 120 seconds. The default is 120
seconds.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Administering the Switch
OL-13270-06