Port Addresses; Implemented And Unimplemented Port Addresses - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

FICON Port Numbering
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Table 24-1 FICON Port Numbering in the Cisco MDS 9000 Family
Slot
Product Number
Cisco MDS Slot 1
9200 Series
Slot 2
Cisco MDS Slot 1
9506 Director
Slot 2
Slot 3
Slot 4
Slot 5
Slot 6
Cisco MDS Slot 1
9509 Director
Slot 2
Slot 3
Slot 4
Slot 5
Slot 6
Slot 7
Slot 8
Slot 9

Port Addresses

By default, port numbers are the same as port addresses (see the
page
You can swap the port addresses by issuing the ficon swap portnumber command.

Implemented and Unimplemented Port Addresses

An implemented port refers to any port address that is available in the chassis (see
An unimplemented port refers to any port address that is not available in the chassis (see
An unimplemented port is prohibited from communicating with an implemented port in a FICON setup
Tip
and cannot be configured.
Cisco MDS 9000 Family Configuration Guide
24-8
Implemented Port Allocation
To Ports To PortChannel/FCIP
0 through 31 64 through 89
32 through 63
0 through 31 128 through 153
32 through 63
64 through 95
96 through 127
None
None
0 through 31 224 through 249
32 through 63
64 through 95
96 through 127
None
None
128 through 159
160 through 191
192 through 223
24-25).
Chapter 24
Unimplemented
Ports Notes
90 through 253 Similar to a switching module.
and port 255
The first 16 port numbers in a
16-port module are used and
154 through 253
the rest remain unused.
and port 255
Supervisor modules are not
allocated port numbers.
250 through 253 The first 16 port numbers in a
and port 255 16-port module are used and
the rest remain unused.
Supervisor modules are not
allocated port numbers.
The first 16 port numbers in a
16-port module are used and
the rest remain unused.
"Port Swapping" section on
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Configuring FICON
Table 24-1).
Table 24-1).