Installing The Thermistor Module On A Cisco 7609-S Router - Cisco 7600-SIP-400 - SPA Interface Processor 400 Installation Manual

Installing the Thermistor Module on a Cisco 7609-S Router

Perform these steps to replace a thermistor module.
Remove the thermistor module by unscrewing two captive thumbscrews (see
Step 1
the termistor module out.
Slide the replacement thermistor module into the chassis and tighten the two captive screws. the single
Step 2
captive screw that retains the thermistor module in the chassis. See
Figure 5-132
Installing the Thermistor Module on a Cisco 7609-S Router
This section describes how to install the thermistor module for the Cisco 7609-S router. The necessary
parts can be ordered at listed in
Part Number
THERM-7609S=
Perform these steps to replace a thermistor module.
Remove the intake panel by unscrewing four captive thumbscrews (see
Step 1
Cisco 7600 Series Router Installation Guide
5-134
Thermistor Module Replacement.
7600- ES20
FA N -10G3 CXL
ST AT US
1
ETHE RNET
SERV ICES
MODU LE
7600- ES20 CLAS S 1 LASE
-10G3 CXL
R
S
06 T6
M-
2 ER TH
ETHE RNET
SERV ICES
MODU LE
7600- ES20 CLAS S 1 LASE
-10G3 CXL
R
3
ETHE RNET
SERV ICES
MODU LE
7600- ES20
-10G3 CXL CLAS S 1 LASE
R
4
ETHE RNET
SERV ICES
MODU LE
CLAS S 1 LASE
R
5
6
Table
Table 5-3
Chapter 5
Cis co 760
6
5-3.
Thermistor Module Part Numbers
Description
Replacement thermistor module
Removal and Replacement Procedures
Figure 5-132) and sliding
Figure 5-132.
Figure 5-133).
OL-4503-26