Cisco 5510 - ASA SSL / IPsec VPN Edition Quick Start Manual page 30

Connecting Interface Cables and Verifying Interface Connectivity
Make sure the PC is configured to obtain an IP address using DHCP. (By default,
the ASA is configured to act as the DHCP server for the management PC;
therefore the ASA assigns the management PC an IP address from a pool.)
Note
Connect your networks to the appropriate ports. If you are using the fiber ports,
Step 2
you need an SFP+ module for 10-Gigabit Ethernet (a license may be required) or
an SFP module for Gigabit Ethernet. (SFP or SFP+ modules are not included.)
Note
1
SFP1
2
SFP1
Unsecure Network
Cisco ASA 5580 Series Quick Start Guide
5-4
If you want to use the CLI, connect your PC to the console port and see
the CLI configuration guide for more information.
The ASA 5585-X with SSP-10 and SSP-20 include 2 SFP/SFP+ and 8
copper Gigabit Ethernet ports (as shown in the following figure). The
ASA 5585-X with SSP-40 and SSP-60 include 4 10-Gigabit Ethernet and
6 Gigabit Ethernet ports.
See the Cisco ASA 5585-X Adaptive Security Appliance Hardware
Installation Guide for more information.
SFP0 7 6 5 4 3 2
7 6 5 4 3 2
SFP0
Chapter 5
0
1
1 0 1 MGMT 0
USB
0
1
1 0 1 MGMT
0 USB
3
Secure Network
Installing the ASA 5585-X
RESET
AUX CONSOLE
RESET
AUX CONSOLE
Management PC
78-19753-01