Contents - Cisco CRS-1 - Carrier Routing System Router Getting Started Manual

RP Redundancy and Hardware Administration on
Cisco IOS XR Software
This chapter describes the command-line interface (CLI) techniques and commands used to manage and
configure the hardware components of a router running the Cisco IOS XR software.

Contents

This chapter contains the following sections:
•
•
•
•
•
•
•
Commands to Display Hardware Status
summarizes the commands commonly used to display the hardware status of a router.
Table 7-1 Commands Used to Display Node and Hardware Status
Command
show platform [nodeID]
show diags [nodeID | details | summary]
show environment [all | fans | leds | power-supply
| table | temperatures | voltages | l]
Commands to Display Hardware Status, page 7-1
Command Syntax for Hardware Nodes (location nodeID), page 7-4
Configure Routing Interfaces, page 7-7
RP Redundancy and Failover, page 7-19
Reloading, Shutting Down, or Power Cycling a Node, page 7-22
Using Controller Commands to Manage Hardware Components, page 7-24
Formatting Hard Drives, Flash Drives, and Other Storage Devices, page 7-25
Description
Displays a summary of the nodes in the system, including node type and
status. You can display information for a single node by specifying the
nodeID. See the
nodeID)" section on page 7-4
Displays detailed information on the hardware components for each
node, including the status of the software running on each node.
Displays hardware information for the system, including fans, LEDs,
power supply voltage and current information, and temperatures.
C H A P T E R
"Command Syntax for Hardware Nodes (location
for more information.
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
7
7-1