Booting And Logging Onto The Cisco Ubr7200 Series; Setting Password Protection On The Cisco Ubr7200 Series - Cisco 7246VXR - uBR Router Software Configuration Manual

Chapter 2 Configuring the Cable Modem Termination System for the First Time

Booting and Logging onto the Cisco uBR7200 Series

The Cisco uBR7200 series router is administered using the Cisco command interpreter, called the EXEC.
You must boot and log in to the router before you can enter an EXEC command.
SUMMARY STEPS
1.
2.
3.
DETAILED STEPS
Command or Action
Step 1 Connect a terminal to the I/O controller console port of the
Cisco uBR7200 series router and establish a terminal
session.
Step 2 Power on the Cisco uBR7200 series router. Enter no to
choose the normal operating mode of the router.
Example:
Would you like to enter the initial dialog?[yes]:
no
Router>
Step 3
Continue to password definition or recovery and additional
configuration.

Setting Password Protection on the Cisco uBR7200 Series

For security purposes, the EXEC has two levels of access to commands: user EXEC mode and privileged
Note
EXEC mode. The commands available at the user level are a subset of those available at the privileged level.
Because many privileged-level EXEC commands are used to set operating parameters, password-protect
Tip
these commands to prevent unauthorized use.
OL-2239-03
Connect a terminal to the I/O controller console port of the Cisco uBR7200 series router and
establish a terminal session.
Power on the Cisco uBR7200 series router. Enter no to choose the normal operating mode of the
router.
Continue to password definition or recovery and additional configuration.
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
Configuration Fundamentals for the Cisco uBR7200 Series
Purpose
You can open a Terminal application (Hyper Terminal)
on a PC as follows:
a. Connect using: Direct to Com 1
Set bits per second: 9600
b.
c. Set data bits: 8
Set parity: none
d.
Set stop bit: 1
e.
Set flow control: hardware
f.
The user EXEC prompt appears.
Refer to the remaining procedures in this chapter.
2-5