Configuring The Cisco Ubr7200 Series Manually Using Configuration Mode - Cisco 7246VXR - uBR Router Software Configuration Manual

Chapter 2 Configuring the Cable Modem Termination System for the First Time
Configure IP? [yes]:
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [1]:
Configure CLNS? [no]:
Configuring interface parameters:
Do you want to configure FastEthernet0/0
Use the 100 Base-TX (RJ-45) connector? [yes]:
Operate in full-duplex mode? [no]:
Configure IP on this interface? [yes]: no
Do you want to configure Ethernet1/0
Do you want to configure Cable5/0
Downstream setting frequency
For cable upstream [0]
Shut down this upstream ? [yes/no]: no
Frequency
Would you like to configure the DHCP server ? [yes/no]: yes
IP address for the DHCP server
[X.X.X.X]: 10.0.0.2
Configure IP on this interface? [no]: yes
IP address for this interface: 10.20.133.65
Subnet mask for this interface [255.0.0.0] : 255.255.255.248
Class A network is 10.0.0.0, 29 subnet bits; mask is /29
The following configuration command script is created:
interface cable5/0
ip address 10.20.133.65 255.255.255.248
no ip mroute-cache
no keepalive
cable insertion-interval 500
cable downstream annex B
cable downstream modulation 64qam
cable downstream interleave-depth 32
cable downstream frequency 531000000
cable upstream 0 frequency 33808000
cable upstream 0 power-level 0
no cable upstream 0 shutdown
cable helper-address 10.0.0.2
For modems to acquire an IP address, they must have direct access to DHCP, TFTP, or ToD servers, or
Note
have a static route set.
Configuring the Cisco uBR7200 Series Manually Using
Configuration Mode
You can configure the Cisco uBR7200 series router manually if you prefer not to use the Setup facility
or AutoInstall. Complete the following steps:
Connect a console terminal to the console port on the I/O controller.
Step 1
When asked if you want to enter the initial dialog, respond no to go into the normal operating mode of
Step 2
the router:
Would you like to enter the initial dialog? [yes]: no
After a few seconds, the user EXEC prompt
Step 3
(configuration changes can be made only in enable mode):
Router> enable
The prompt changes to the enable mode (also called privileged EXEC) prompt:
Router#
OL-2239-03
: 531000000
: 33808000
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide

Configuring the Cisco uBR7200 Series Manually Using Configuration Mode

interface? [yes]:
interface? [yes]: n
interface? [yes]:
appears. Type enable to enter enable mode
(Router>)
2-27