Creating An Ft Vlan; Configuring An Ft Vlan Ip Address - Cisco ACE-4710-K9 Administration Manual

Chapter 7 Configuring Redundant ACE Appliances

Creating an FT VLAN

Note

Configuring an FT VLAN IP Address

OL-11157-01
On both peer ACE appliances, you must configure the same Ethernet port or
port-channel interface as the FT VLAN port. For example:
If you configure ACE appliance 1 to use Ethernet port 4 as the FT VLAN port,
•
then be sure to configure ACE appliance 2 to use Ethernet port 4 as the FT
VLAN port.
If you configure ACE appliance 1 to use port-channel interface255 as the FT
•
VLAN port, then be sure to configure ACE appliance 2 to use port-channel
interface 255 as the FT VLAN.
To create an FT VLAN, use the ft interface command in configuration mode. The
syntax of this command is:
ft interface vlan vlan_id
The vlan_id argument specifies a unique identifier for the FT VLAN. Enter an
integer from 2 to 4094.
For example, enter:
host1/Admin(config)# ft interface vlan 200
host1/Admin(config-ft-intf)#
To remove an FT VLAN, first remove it from the FT peer by using the no
ft-interface vlan command in FT peer configuration mode. See the
the FT VLAN with the Local Peer"
To remove the FT VLAN from the redundancy configuration, enter:
host1/Admin(config)# no ft interface vlan 200
After you create the FT VLAN, you must assign an IP address to the VLAN. To
assign an IP address to the VLAN, use the ip command in FT interface
configuration mode. The syntax of this command is:
ip address ip_address netmask
Cisco 4700 Series Application Control Engine Appliance Administration Guide
section.
Configuring Redundancy
"Associating
7-13