Cisco ACE-4710-K9 Administration Manual page 126

Class Map and Policy Map Configuration Quick Start
Table 4-1
Task and Command Example
9.
10.
Table 4-2
Task and Command Example
1.
2.
Cisco 4700 Series Application Control Engine Appliance Administration Guide
4-12
Layer 3 and Layer 4 Network Traffic Class Configuration
Quick Start (continued)
(Optional) Specify the destination IP address and subnet mask as a matching
criteria in the class map.
host1/Admin(config-cmap)# match destination-address 172.16.20.1
255.255.0.0
(Optional) Specify a TCP or UDP port number or port range as a matching
criteria in the class map.
host1/Admin(config-cmap)# match port tcp eq 23
Layer 3 and Layer 4 Network Management Traffic Class
Configuration Quick Start
If you are operating in multiple contexts, observe the CLI prompt to verify
that you are operating in the desired context. If necessary, log directly in to,
or change to, the correct context.
host1/Admin# changeto C1
host1/C1#
The rest of the examples in this table use the Admin context, unless
otherwise specified. For details on creating contexts, see the Cisco 4700
Series Application Control Engine Appliance Virtualization Configuration
Guide.
Enter configuration mode.
host1/Admin# config
Enter configuration commands, one per line. End with CNTL/Z
host1/Admin(config)#
Chapter 4 Configuring Class Maps and Policy Maps
OL-11157-01