802.1X Port Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual

Table 104 802.1x Global Configuration Menu options
Command
maxreq <1-10>
raperiod <1-604800>
reauth on|off
default
cur

802.1x Port configuration

Command: /cfg/l2/8021x/port <port number>
[802.1x Port Configuration Menu]
mode
qtperiod - Set EAP-Request/Identity quiet time interval
txperiod - Set EAP-Request/Identity retransmission timeout
suptmout - Set EAP-Request retransmission timeout
svrtmout - Set server authentication request timeout
maxreq
raperiod - Set reauthentication time interval
reauth
default
global
cur
The 802.1x port menu allows you to configure parameters that affect the selected port in the switch. These settings
override the global 802.1x parameters.
The following table describes the 802.1x Port Configuration Menu options.
Table 105 802.1x Global Configuration Menu options
Command
mode force-
unauth|auto|force-auth
qtperiod <0-65535>
txperiod <1-65535>
suptmout <1-65535>
svrtmout <1-65535>
maxreq <1-10>
Description
Sets the maximum number of times the authenticator retransmits an EAP-Request
packet to the supplicant (client). The default value is 2.
Sets the time, in seconds, the authenticator waits before re-authenticating a
supplicant (client) when periodic re-authentication is enabled. The default value
is 3600 seconds.
Sets the re-authentication status to
Resets the global 802.1x parameters to their default values.
Displays current global 802.1x parameters.
- Set access control mode
- Set max number of EAP-Request retransmissions
- Set reauthentication status to on or off
- Restore default 802.1x configuration
- Apply current global 802.1x configuration to this port
- Display current 802.1x configuration
Description
Sets the type of access control for the port:
force-unauth
- the port is unauthorized until it is successfully authorized by the
auto
RADIUS server.
force-auth
The default value is
Sets the time, in seconds, the authenticator waits before transmitting an EAP-
Request/ Identity frame to the supplicant (client) after an authentication failure
in the previous round of authentication. The default value is 60 seconds.
Sets the time, in seconds, the authenticator waits for an EAP-Response/Identity
frame from the supplicant (client) before retransmitting an EAP-Request/Identity
frame. The default value is 30 seconds.
Sets the time, in seconds, the authenticator waits for an EAP-Response packet
from the supplicant (client) before retransmitting the EAP-Request packet to the
authentication server. The default value is 30 seconds.
Sets the time, in seconds, the authenticator waits for a response from the
RADIUS server before declaring an authentication timeout. The default value is
30 seconds.
The time interval between transmissions of the RADIUS Access-Request packet
containing the supplicant's (client's) EAP-Response packet is determined by the
current setting of
Sets the maximum number of times the authenticator retransmits an EAP-Request
packet to the supplicant (client). The default value is 2.
or . The default value is
on off
- the port is unauthorized unconditionally.
- the port is authorized unconditionally, allowing all traffic.
.
force-auth
/cfg/sys/radius/timeout
.
off
(default is 3 seconds).
Configuration Menu 111