Honeywell HPL624 Product Installation Document

Honeywell
12 Clintonville Road
Northford, CT 06472-1610
http://www.honeywellpower.com
1 Introduction
The HPL624 power supply/battery charger converts a low voltage AC input into an output of 6 VDC or 12 VDC @ 1.2
amps of continuous supply current or 24 VDC @ 750 mA of continuous supply current. This general purpose linear
power supply can provide additional power for a variety of applications such as access control, security and CCTV system
accessories.

2 Specifications

• Switch selectable for 6 VDC, 12 VDC or 24 VDC output.
• 1.2 amps of continuous supply current at 6 VDC or 12 VDC.*
• 750 mA of continuous supply current at 24 VDC.*
• Output that is filtered and electronically regulated.
• Built-in charger for sealed lead acid or gel type batteries.
• Maximum charge current of 500 mA.
If a battery charger is used, subtract max charge current of
500 mA from total to determine allowable load.
• Automatic switchover to stand-by battery upon AC fail.
• PTC battery protection.
• Thermal and short circuit protection with auto reset.
• LED indicators for AC input and DC output.
• Compact design (board dimension 3"L x 2.5"W x 1.5"H).
• Battery leads and foam mounting tape included.
*Specified at 25ºC ambient.
3 Voltage Output and Transformer Selection
Output Voltage/Current
12 VDC @ 1.2 amps continuous supply current
24 VDC @ 750 mA continuous supply current
6 VDC @ 1.2 amps continuous supply current
PN 52263:C
Switch
Transformer Requirements
SW1 SW2
Closed Closed
Open Closed
Closed Open
HPL624
Power Supply/Battery Charger
1/10/08 ECN 08-029
Product Installation Document
DC LED
TB1
BAT +
DC –
DC +
AC
AC
AC LED
16.5VAC / 40 VA
(model HTP1640)
24VAC / 40 VA
(model HTP2440)
12VAC / 20 VA
(model HTP1220)