Further Notes; Testing; Managing Devices - NETGEAR UTM10 - ProSecure Unified Threat Management Appliance Application Note

Further Notes

Testing

Testing can be performed by connecting a Wireless client to each of the SSID alternatively (i.e.
Corporate, Guest, Engineering) and trying to access the Internet or ping the IP address assigned
to the UTM in the VLAN associated to the SSID.
Ensure the Wireless client obtains an IP address from a DHCP server or hard-code an IP address
relevant to the VLAN the Wireless client will be connecting to.
Inter-VLAN routing will work between VLANs if the following option is enabled in both the source
and destination VLAN:

Managing devices

UTM
The unit will be managed using the IP address configured on the VLAN the
managing device will try to connect from.
The unit will therefore be accessible using 192.168.1.1 in VLAN1, 192.168.20.1 in
VLAN 20 and 192.168.30.1 in VLAN 30.
WNDAP330
The unit will be managed, upon being configured, from a device (wired or wireless)
connected to a port in VLAN1 ,as VLAN 1 is the management VLAN for the Access
Point (IP 192.168.1.235)
Layer2/Layer3 switch
The unit will be managed connecting to a port in VLAN1, as this is the management
VLAN for the switch (192.168.1.239)
Version 2.0