NETGEAR UTM9S Installation Manual

UTM9S_IG_20June11.fm Page 1 Thursday, June 23, 2011 9:02 AM
ProSecure™ Unified Threat Management Appliance UTM9S
Note: Electronic License
This product includes an electronic license
activated automatically by product registration.
Follow these instructions to configure your ProSecure Unified Threat Management
appliance to use a single WAN interface, and enable the default threat management
scanning. Then, consult the Reference Manual for instructions on configuring other
options such as multiple WAN settings, VPN, firewall, and custom scanning. You
can access the Reference Manual from the product management interface, via the
Resource CD and from the NETGEAR support site: http://support.netgear.com.
Estimated time: 30 minutes.
Verify the Package Contents
• ProSecure™ UTM9S appliance.
• Installation Guide.
• Resource CD.
• Rubber feet (4) with adhesive backing.
• Rack mount brackets (some models).
• Power cord.
Familiarize Yourself with the Unit and Complete Setup
Familiarize yourself with the ports and status lights on the front of the unit.and with
the connectors and controls on the back of the unit.
1. Power and Test LEDs 2. USB port (future use)
4. LAN port 4 DMZ 5. Gigabit WAN ports,
Installation Guide
1 2 3
7. Kensington lock
8. Factory reset button
7
8
9
Connect the Unit
For initial setup, connect the WAN Ethernet port to an active WAN connection such
as a broadband modern, connect a DHCP enabled PC to a LAN port, and turn on
the unit.Verify the following:
• Power LED: It takes about a minute to boot. The power LED should turn solid
green. If it does not, see the Troubleshooting section of the Reference Manual.
• Test LED: When you first turn on the unit, the amber test LED will be lit for
approximately 2 minutes.
• WAN Status LED: The status LED on the connected WAN port should be lit. If
not, make sure the Ethernet cable is securely attached to the modem and the
WAN port, and that the modem is powered on.
3. Gigabit LAN ports
• LAN Status LED: A LAN status LED should be lit. If not, ensure that the Ethernet
6. Accessory modules
cable from the computer to the unit is securely attached at both ends, and that
the computer is turned on.
4 5 6
9. Module selection for console 11. Power connector
10. Console port
10
11
Log in to the Unit
1. Use a browser to connect to
https://192.168.1.1
https://192.168.1.1.
2. When prompted, enter admin for the
User Name and password for the
Password. Click Login.
You are now connected. After 5 minutes of
inactivity (the default login time-out), you
are automatically logged out.
Note: When the unit scans secure HTTPS
traffic, import its root CA certificate into client
browsers. Click the link at the bottom of the
login screen to download it.
Use the Setup Wizard for Basic Configuration
The Setup Wizard will guide you through the basic network and scanning setup.
Note: If you choose to bypass the Setup Wizard, be sure to configure an alerts e-
mail address and change the admin password.
1. Start the Setup Wizard.
Select Wizards > SetupWizard
to start the wizard.
For guidance on how to fill in
the wizard screens, refer to the
online help or the Reference
Manual via a link in the
Support > Documentation
page.